Power electronics for equipment manufacturers & integratorsinfo@voluxin.com+86 15957148220
Request a Quote ↗

VOLUXIN · POWER & BATTERY MANAGEMENT

Engineering resources

Selection guides, English product overviews and project requirements.

BA48-MNS11 — BMS catalogue reference
350V DC-DC Converter Range — DC-DC catalogue reference

VOLUXIN ENGINEERING REFERENCE

DC-DC load review worksheet

Source window, auxiliary loads, cooling and evaluation conditions.

← All engineering references

Download CSV

Read the table below. On small screens, scroll horizontally to view every column. Download the CSV to edit a worksheet in your spreadsheet application.

DC-DC load review worksheet — Revision 2, 5 October 2026
Review itemRequirement to specifyYour target / notes
Supply windowSource type; minimum/maximum steady input; transient amplitude and durationTo be provided by customer
Output railsVoltage and tolerance; continuous current; start-up demand for each loadTo be provided by customer
Duty profileActive; idle; sleep; start-up states and time spent in eachTo be provided by customer
IsolationRequired isolation boundaries; test method; system grounding to agreeTo be provided by customer
Regulation and rippleLine/load regulation targets; ripple measurement bandwidth and setupTo be provided by customer
EfficiencyRequested input/load operating points; auxiliary consumption to includeTo be provided by customer
ThermalAmbient; available cooling; interface; continuous duty and derating needsTo be provided by customer
ControlsEnable/wake; signal levels; start-up/shutdown sequence; status messagesTo be provided by customer
ProtectionUndervoltage; overvoltage; overload; short-circuit; recovery behaviourTo be provided by customer
InstallationModule/enclosed; space; fasteners; connector and harness drawingTo be provided by customer
Evaluation and orderSample quantity; required records; target date; repeat-order volumeTo be provided by customer

VOLUXIN | Rev 2 | 2026-10-05 | Customisation requirements worksheet; targets are customer inputs, not confirmed product specifications or test results.

Custom DC-DC converters: specify the source, loads and installation

A custom DC-DC converter enquiry should identify every output rail and the full supply window. Module and enclosed constructions can be reviewed against the equipment mounting and cooling arrangement.

Discussion topicWhat to specify
Input and outputSeparate nominal voltage, operating limits and transients; state each output tolerance.
Isolation and controlsDefine isolation needs, enable signals, start-up sequence and fault behaviour.
Efficiency and temperatureRequest evaluation at identified input, load and cooling conditions.
Power and mechanicsSeparate continuous and start-up demand; provide mounting space and connector requirements.

Selection trade-off

Compact packaging and high output power increase the importance of thermal integration. Compare power at the intended operating point rather than using peak efficiency as a whole-system guarantee.

Continue the selection guide

Industry reading: Vicor DC-DC datasheet: specification categories. Source documents inform the review topics; their product ratings, certifications and capabilities are not VOLUXIN specifications.

Request a Custom DC-DC Review

Catalogue references and blank worksheets support project discussions. They are not configuration-specific engineering specifications or completed test records.

Discuss Your Requirements